Rohde & Schwarz FSVA - Page 745

Remote Control
R&S
®
FSVA/FSV
745Operating Manual 1176.7510.02 ─ 09
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel....................................................... 750
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RLEVel:OFFSet........................................... 751
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RPOSition................................................... 751
DISPlay[:WINDow<n>]:TRACe<t>:Y[:SCALe]:RVALue...................................................... 752
DISPlay[:WINDow<n>]:ZOOM:AREA............................................................................... 752
DISPlay[:WINDow<n>]:ZOOM:STATe..............................................................................753
DISPlay:MTABle <DisplayMode>
This command turns the marker table on and off.
Parameters:
<DisplayMode> ON
Marker table is displayed.
OFF
Marker table is not displayed.
AUTO
Marker table is only displayed if 2 or more markers are active.
*RST: AUTO
Example: To activate the table display:
DISP:MTAB ON
To query the current state of the marker table display:
DISP:MTAB?
Manual operation: See "Marker Table" on page 282
DISPlay[:WINDow<n>][:SUBWindow<m>]:SIZE <Size>
This command configures the measurement display.
Suffix:
<n>
.
1 | 2
window;
Channel and adjacent-channel power measurements: Only "1" is
allowed as a suffix for the window.
Spectrum Emission Mask and Spurious Emissions measure-
ments:
selects the window that is displayed in full size (if no suffix is
defined, "1" is used):
1: diagram/result list
2: marker table
<m> 1 | 2
selects the item in the window to be displayed in full size:
1: diagram
2: result list
Remote Control – Commands