Rohde & Schwarz FSVA - Page 748

Remote Control
R&S
®
FSVA/FSV
748Operating Manual 1176.7510.02 ─ 09
Manual operation: See "Clear Write" on page 253
See "Max Hold" on page 253
See "Min Hold" on page 253
See "Average" on page 254
See "View" on page 254
DISPlay[:WINDow<n>]:TRACe<t>:MODE:HCONtinuous <State>
This command defines whether traces in Min Hold, Max Hold and Average mode (see
DISPlay[:WINDow<n>]:TRACe<t>:MODE on page 747) are reset after a parameter
is changed.
Normally, the measurement is started anew after parameter changes, before the mea-
surement results are evaluated (e.g. using a marker). In all cases that require a new
measurement after parameter changes, the trace is reset automatically to avoid false
results (e.g. with span changes). For applications that require no reset after parameter
changes, the automatic reset can be switched off.
Suffix:
<n>
.
window; For applications that do not have more than 1 measure-
ment window, the suffix <n> is irrelevant.
<t> trace
Parameters:
<State> ON
The automatic reset is switched off.
OFF
After certain parameter changes the traces are reset.
*RST: OFF
Example: DISP:WIND:TRAC3:MODE:HCON ON
Switches off the reset function.
Manual operation: See "Hold/Cont" on page 254
DISPlay[:WINDow<n>]:TRACe<t>:X:SPACing <ScalingType>
This command toggles between linear and logarithmic display of the x-axis.
Suffix:
<n>
.
window; For applications that do not have more than 1 measure-
ment window, the suffix <n> is irrelevant.
<t> irrelevant
Remote Control – Commands