Remote Control Commands
R&S
®
SMB100A
430Operating Manual 1407.0806.32 ─ 13
<RadioTextMsg> max. 64 characters
Two texts of 64 characters each can be transmitted in a radio text
message
Note: For group B, the length of a radio text is li ited to 32 char-
acters. Special characters in the radio text are entered with a
leading back slash (\) followed by the decimal code of the spezial
character according to tabe E1 of CENELEC.
Example: STER:DIR "RT=02,0,test text with \217" 217
denotes the German ü.
Example:
STEReo:DIRect "RT=02,1,Test message 123"
The radio text message "Test message 123" is transmitted.
Example:
STEReo:DIRect? "RT"
Response: "02,1,Test message 123"
STEReo:DIRect "SPS=<Time>,<PSN#1>,<PSN#2>,...<PSN#20>"
STEReo:DIRect? "SPS"
Switching program service names (PSN). The program name automatically changed
after the set time interval
Parameters:
<PSN> 8 ASCII characters
Max. 20 program service names of eight characters each can be
entered.
Note: The program service names have to be entered as 8-digit
texts. Blank spaces, if any, must also be entered, otherwise the
value will not be accepted.
STEReo:DIRect “SPS=0” stopps the transmission of the scroll-
ing PS beendet and starts the transmission of the standard PS.
Setting parameters:
<Time> Time interval in seconds
Range: 00 to 59 s
Example:
STEReo:DIRect "SPS=05,TEST0123,TEST4567"
The program service names "TEST0123" and "TEST4567" are
alternately transmitted at an interval of 5 seconds.
Example:
STEReo:DIRect? “SPS“
Queries the program service names
Response: "05,TEST0123,TEST4567"
STEReo:DIRect "SRC=<SigSource>"
STEReo:DIRect? "SRC"
(for documentation reasons only)
Selects the signal source.
Use the SCPI command [:SOURce]:STEReo:SOURce instead.
Direct Commands for the Stereo/RDS Coder Option R&S SMB-B5
To Next Page
Loading...
