Getting Started
R&S
®
SMB100A
51Operating Manual 1407.0806.32 ─ 13
2. Configure and activate RF frequency sweep.
a) Turn the rotary knob and select the "RF" block.
b) Press the rotary knob to open the dialog where the RF frequency sweep can be
selected.
c) Turn the rotary knob and highlight "RF Frequency Sweep...".
Press the rotary knob to open the "RF Frequency Sweep" dialog.
All sweep parameters are default except for the sweep mode. The default settings
are not changed.
d) Turn the rotary knob to select parameter "Mode", press the rotary knob to open
the selection list and select "Single".
e) Press the rotary knob to apply the selection.
For triggering, the "Execute Single Sweep" and "Reset Sweep" buttons are dis-
played.
Example of Setup
To Next Page
Loading...
