SICK Lector62 Series User Manual

Control system
The Control system parameter allows you to choose between a configuration based on
length units and a configuration based on time units.
•
DISTANCE-CONTROLLED: The configuration is based on distance increments in mm.
These are either generated by the configuration software (SOPAS)/CAN interface
or via a rotary encoder at the digital input.
•
TIME-CONTROLLED: The configuration is based on times entered in ms.
Sensitivity
The Empfindlichkeit parameter allows you to choose between edge control and level
control.
•
EDGE: The digital input responds to the switch between Low (0) and High (1)
according to how the Logic parameter is configured. Any signal that is permanently
present is ignored.
•
LEVEL: The digital input responds to a permanently present signal according to how
the Logic parameter is configured.
Logic
The Logic parameter is used to select the polarity for the Sensitivity parameter.
•
NOT INVERTED: The digital input responds to a rising edge, i.e., to a switch from Low
(0) to High (1), or to a High signal (1) that is permanently present.
•
INVERTED: The digital input responds to a falling signal edge, i.e., to a switch from
High (1) to Low (0), or to a Low signal (0) that is permanently present.
Debouncing
Depending on how the Control system parameter is configured, the Debouncing param‐
eter specifies the minimum distance in mm or the minimum time in ms for the signal at
the external input. If the value is not achieved, the signal is not detected.
Depending on the application, this value may have to be adapted in line with the read
cycle rates required.
321
Serial
The Serial tab contains parameters for configuring the serial host and aux interfaces.
The serial host interface is typically used for communication with the control (PLC). The
serial aux interface is used to configure the reading device separately.
322 Serial Aux
The Serial Aux group contains the parameters for configuring the serial aux interface.
The serial aux interface is typically used for configuring and analyzing the sensor.
As the configuration of the interface cannot be changed on the sensor, the settings
must be adapted on the connected device (e.g., PC or control).
SOPAS PARAMETER OVERVIEW
8013778/YPV6/2016-01-14 | SICK O N L I N E H E L P | Lector62x
107
Subject to change without notice

SICK Lector62 Series Specifications

General

Brand	SICK
Model	Lector62 Series
Category	Barcode Reader
Language	English