336 Save Destination
The Save Destination group contains the parameters for saving the image files. The
save destination determines the media that is used to store the images.
NOTE
The storage media selection affects the storage times. Saving the data to the internal
memory or onto a microSD memory card takes significantly longer than other storage
options. It is therefore recommended to select the INTERNAL MEMORY (PERMANENT) storage
option or the SOPAS (PC) storage option at high reading speeds. Only one storage option
should be activated at high reading speeds.
337 Stacked Symbologies Active
If the GS1 DataBar parameter is activated, decoding is activated for the DataBar 14,
DataBar Expanded, and DataBar Limited activated code types. (This requires the GS1
DataBar code type to be deactivated.)
NOTE
As only activated code types are processed, you can increase the processing speed by
deactivating the code types that are not being used.
338 Standard gateway
The Standard gateway parameter is used to specify the IP address of a gateway to
implement the network protocol. Before this can happen, a connection must be estab‐
lished with the sensor at the SERVICE EMPLOYEE user level.
NOTE
The IP-Address and Subnet mask parameters can be changed via the connection wiz‐
ard if the AUTHORIZED CUSTOMER user level is accessed.
339 Stacked Symbologies
The Stacked Symbologies group contains all the parameters for configuring what are
known as "stacked symbologies" (multiple bar codes that are stacked one on top of the
other in rows and all have the same start and end characters).
SOPAS PARAMETER OVERVIEW
8013778/YPV6/2016-01-14 | SICK O N L I N E H E L P | Lector62x
111
Subject to change without notice
To Next Page
Loading...
Need help?
General
