SIMATIC RF200
System Manual, 07/2015, J31069-D0227-U001-A9-7618
89
Pulling and plugging readers
Pull or plug the reader only when the power supply is turned off
If this is not observed, under certain conditions, the reader will not start up correctly and
communication with a transponder will not be possible.
Note
IO-Link variants of the RF200 readers
The IO
-Link variants of the readers are not included in the system manual. You will find
these in the "SIMATIC RF200 IO
-Link
https://support.industry.siemens.com/cs/ww/en/view/60641859)" operating instructions.
To Next Page
Loading...
Need help?
General