Siemens SIMATIC Ident - Mounting on Metal

Transponder
7.26 MDS D524
SIMATIC RF200
290 System Manual, 07/2015, J31069-D0227-U001-A9-7618
7.26.3
Mounting on metal
Mounting on metal
h
≥ 15 mm
Figure 7-68 Mounting the MDS D524 on metal with spacer
Flush-mounting
h
≥ 15 mm
a
≥ 25 mm
Figure 7-69 Flush-mounting of the MDS D524 in metal with spacer
Note
If the minimum guide values (h) are not observed, a reduction of the field data results. It is
possible to mount the MDS with metal screws (M3 countersunk
head screws). This has no
tangible impact on the range.