Appendix
A.2 Accessories
SIMATIC RF200
322 System Manual, 07/2015, J31069-D0227-U001-A9-7618
● Wide-range power supply unit for SIMATIC RF systems
● 2 m mains cable (country-specific)
● Protective cover for flange outlet
● Operating Instructions
Table A- 6 Ordering data for wide-range power supply unit
Wide-range power supply unit for SIMATIC RF systems (100 -
240 VAC / 24 VDC / 3 A) with 2 m connecting cable with country-
EU: 6GT2898-0AA00
UK: 6GT2898-0AA10
24 V-connecting cable, length 5 m 6GT2491-1HH50
It is not permitted to open the device or to modify the device.
The following must also be taken into account:
• Failure to observe this requirement shall constitute a revocation of the CE approval, UL
certification for the US and Canada as well as the manufacturer's warranty.
• For installation of the power supply, compliance with the DIN/VDE requirements or the
country-specific regulations is essential.
• The field of application of the power supply unit is limited to "Information technology
equipment" within the scope of validity of the EN 60950/VDE 0805 standard.
• When the equipment is installed, it must be ensured that the mains socket outlet is
freely accessible.
• The housing can reach a temperature of +25 °C during operation without any adverse
consequences. It must, however, be ensured that the power supply is covered in the
case of a housing temperature of more than +25°C to protect persons from contact with
the hot housing. Adequate ventilation of the power supply must be maintained under
these conditions.
Area of application of the wide-range power supply unit
The wide-range power supply unit may only be used for SIMATIC products in the
specifically described area of application and for the documented purpose.
To Next Page
Loading...
Need help?
General