Siemens SIMATIC Ident - Mounting on Metal

Transponder
7.13 MDS D339
SIMATIC RF200
System Manual, 07/2015, J31069-D0227-U001-A9-7618
235
7.13.3
Mounting on metal
Direct mounting of the MDS D339 on metal is not allowed. A distance of ≥ 30 mm is
recommended. This can be achieved using spacers, see Transponder holders (Page 329).
Mounting on metal
h
≥ 30 mm
Figure 7-27 Mounting the MDS D339 on metal with spacer
Flush-mounting
It is possible to mount the MDS D339 in metal. With large antennas, for example ANT D5,
this leads to a reduction of ranges.
h
≥ 30 mm
a
≥ 100 mm
Figure 7-28 Flush-mounting of the MDS D339 in metal with spacer