Siemens SIMATIC Ident - Polyphenylene Sulfide (PPS)

RF200 system planning
4.3 Installation guidelines
SIMATIC RF200
System Manual, 07/2015, J31069-D0227-U001-A9-7618
81
Note
Chemical substances not listed
The following sections describe the resistance of the various
transponders to specific
substances. If you require information about chemical substances that are not listed, contact
Customer Support.
4.3.6.2
Polyphenylene sulfide (PPS)
The data memory has special chemical resistance to solutions up to a temperature of 200
°C. A reduction in the mechanical properties has been observed in aqueous solutions of
hydrochloric acid (HCl) and nitric acid (HNO3) at 80 °C. The plastic housings are resistant to
all types of fuel including methanol.
Table 4- 30 Chemical resistance - polyphenylene sulfide (PPS)
Substance
Test conditions
Rating
Concentration [%]
Temperature [°C]
Acetone
55 ℃
عربي
n-Butanol (butyl alcohol)
80 ℃
عربي
Butanone-2 (methyl ethyl ketone)
60 ℃
عربي
n-Butyl acetate
80 ℃
عربي
Brake fluid
80 ℃
عربي
Calcium chloride (saturated)
80 ℃
عربي
Diesel fuel
80 ℃
عربي
Diethyl ether
23 ℃
عربي
Frigen 113
23 ℃
عربي
Anti-freeze
120 ℃
عربي
Kerosene
60 ℃
عربي
Methanol
60 ℃
عربي
Engine oil
80 ℃
عربي
Sodium chloride (saturated)
80 ℃
￮￮￮￮
Sodium hydroxide 30% 80 ℃ ￮￮￮￮
Sodium hypochlorite
(30 or 180 days)
5%
80 ℃
￮￮
5% 80 ℃ -
Sodium hydroxide solution
30%
90 ℃
￮￮￮￮
Nitric acid
10%
23 ℃
￮￮￮￮
Hydrochloric acid
10%
80 ℃
-
Sulfuric acid
10%
23 ℃
￮￮￮￮
10%
80 ℃
￮￮
30%
23 ℃
￮￮￮￮
Tested fuels
80 ℃
￮￮￮￮