SimCom SIM5300E

SIM5300E AT Command Manual V1.02
95
OK
if <mode>=3
+CENG: <mode>,<Ncell>
[+CENG: <cell>,<mcc>,<mnc>,<lac>,<cellid>,<bsic>,<rxl>
<CR><LF>+CENG: <cell>,<mcc>,<mnc>,<lac>,<cellid>,<bsic>,<rxl>…]
OK
In 3G mode
If <mode>=1
network is UMTS
+CENG:<ID>,<dl_uarfcn>,<mcc>,<mnc>,<lac>,<cellid>,<psc>,<rscp>,<rxlev),<
tx_pwr>
[+CENG: <ID>,<dl_uarfcn>,<psc>,<rscp>,<ecn0>,[<pathloss>]
<CR><LF>+CENG: <ID>,<dl_uarfcn>,<psc>,<rscp>,<ecn0>,[<pathloss>…]
OK
If <mode>=2, TA activates the unsolicited reporting of network information.
network is UMTS
+CENG:<ID>,<dl_uarfcn>,<mcc>,<mnc>,<lac>,<cellid>,<psc>,<rscp>,<rxlev),<
tx_pwr>
[+CENG: <ID>,<dl_uarfcn>,<psc>,<rscp>,<ecn0>,[<pathloss>…]
<CR><LF>+CENG: <ID>,<dl_uarfcn>,<psc>,<rscp>,<ecn0>,[<pathloss>…]
OK
Write Command
AT+CENG=<mode>[,<Ncell>]
Response
Switch on or off engineering mode. It will repor
t +CENG: (network
information) automatically if <mode>=2.
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters <mode>
0 Switch off engineering mode
1 Switch on engineering mode(display the cell details)
2 Switch on engineering mode, and activate the
URC report of network information(display the cell information
automatically)
3 Switch on engineering mode, with limited URC report(display
the concise cell information)
4 display the serving cell information
SIMCOM CONFIDENTIAL FILE