SIM5300E AT Command Manual V1.02
alpha
numeric representation of <da> or <oa> corresponding to the entry
found in MT phonebook; implementation of this feature is manufacturer
specific
<da> GSM 03.40 TP-Destination-Address Address-
format; BCD numbers (or GSM default alpha
bet characters) are converted to
characters of the currently selected TE character set (specified by +CSCS in
3GPP TS 27.007); type of address given by <toda>
<data> In the case of SMS: GSM 03.40 TP-User-
responses; format:
if <dcs> indi
cates that GSM 03.38 default alphabet is used and <fo> indicates
that GSM 03.40 TPUser-Data-Header-Indication is not set:
if TE character set other than "HEX" (refer Command Select TE Character Set
+CSCS in 3GPP TS 27.007):ME/TA converts GSM alphabet into current TE
character set according to rules of Annex A
if TE character set is "HEX": ME/TA converts each 7-
alphabet into two IRA character long hexadecimal number (e.g. character P
(GSM 23) is presented as 17 (IRA 49 and 55))
if <dcs> indicates that 8-bit or UCS2 data coding scheme is used, or <fo>
indicates that GSM 03.40 TP-User-Data-Header-
converts each 8-bit octet into two IRA character long hexadecimal number
(e.g. octet with integer value 42 is presented to TE as two characters 2A (IRA
50 and 65)) In the case of CBS: GSM 03.41 CBM Content of Message in text
mode responses; format:
if <dcs> indicates that GSM 03.38 default alphabet is used:
if TE character set other than "HEX" (refer Command +CSCS in 3G
27.007): ME/TA converts GSM
alphabet into current TE character set
according to rules of Annex A
if TE character set is "HEX": ME/TA converts each 7-
alphabet into two IRA character long hexadecimal number
if <dcs> indicates that 8-
bit or UCS2 data coding scheme is used: ME/TA
converts each 8-bit octet into two IRA character long hexadecimal number
<dcs> D
epending on the Command or result code: GSM 03.38 SMS Data
Coding Scheme (default 0), or Cell Broadcast Data Coding Scheme in integer
format
To Next Page
Loading...
Need help?
General
