Strata CIX 100 - Page 263

Trunks
Strata CIX Programming Vol.1 12/09 6-9
Trunks
04 Dial Mode Enter the Dial Mode.
Possible values:DP 10PPS, DP 20PPS or DTMF (default)
• DP 10 PPS = Rotary Dial, 10 PPS
• DP 20 PPS = Rotary Dial, 20 PPS
05 Signaling Enter the signaling type.
Possible values:DID,
Loop (default), Ground, Tie, LP (Jpn), SR (Jpn) or ACU (UK)
06 Start Method Enter the Start Method. This setting defines the start protocol method used
between the PSTN and this trunk (for DID/Tie trunks).
Possible values:Immediate Start (default), Timing Start or Wink Start
07 Release Supervision Enable Release Supervision from the CO.
Possible values:Received or Not Received (default)
Note When assigning CAMA trunks for E911 (R2.22 MH232 and later, or
M3.10 MK024 and later systems) set this to Enabled.
08 Answer Supervision Enable Answer Supervision from the CO.
Possible values:Received or Not Received (default)
Note When assigning CAMA trunks for E911 (R2.22 MH232 and later, or
M3.10 MK024 and later systems) set this to Enabled.
09 Trunk Name Enter the trunk name.
Possible values:Up to 14 ASCII characters (default = no value)
10 External Ring Repeat This option determines what ring signal is sent to telephones when a line rings
the telephone. Select Supplied (CO Ring Repeat) to use the ring signal supplied
by the CO or Centrex line. Select Not Supplied (CIX Ring) to use the standard
ring signal supplied by the CIX.
Important! Ring Not Supplied must be used on all DISA lines for proper ringing
operation.
Possible values:Supplied (CO Repeat) - (default) or Not Supplied (CIX Ring)
11 DTMF Back Tone Select DTMF Back Tone type.
Possible values:Padded, DTMF Tone (default) or No Tone
12 Hunt Order The order within the trunks OLG in which the trunk will be seized for outgoing
calls.
Enter 1 for the first trunk seized, 2=next trunk, etc. Enter 999 for the last trunk to
be seized.
Possible values:1~264 or Last One (default = 1)
F
IELD DESCRIPTION