Trunks
Trunk DID/DNIS Setup Wizard
Strata CIX Programming Vol.1 12/09
6-45
Trunks
FIELD DESCRIPTION
GCO Key Group If a Group CO Key is selected, all selected DID/DNIS numbers will ring on
telephones that have this key.
Note This selection will override any GCO or Pool Key Group assignment
made in the Program 304, ILG assignments. Day/Day2/Night period
assignments do not apply; GCO or Pool Keys will ring in all periods.
Pool Key Group If a Pool Key Group is selected, all selected DID/DNIS numbers will ring on
telephones that have this key.
Note This selection will override any GCO or Pool Key Group assignment
made in the Program 304, ILG assignments. Day/Day2/Night period
assignments do not apply; GCO or Pool Keys will ring in all periods.
Set for Period DID/DNIS ringing assignments can be unique for each CIX time period: Day,
Day2 and Night. Select the period(s) in which the destinations should ring. Then
select the destination type.
Destination Type Select the type of destination:
DISA - to call in and receive DISA dial tone.
Built-in modem - to call in directly to the CIX modem with eManager.
Night Bell - to call in and close the BIOU or ACTU night bell control relay.
Dialing Digits - to call in and:
• Ring PDNs, PhDNs, and/or Pilot Numbers.
• Night Ring over External Page - feature access code must be included in the
dialing digits.
• Access outgoing CO lines, Network Nodes and/or LCR to set up tandem calls
- line access codes must be included in the dialing digits.
Note When Dialing Digits is the selected Destination Type you must set the
Dialing Digit Range below.
This selection will override any GCO or Pool Key Group assignment
made in this Program or Program 304, ILG assignments.
Set the Dialing Digits
Range
Select the method in which dialing digit ringing destinations should be created:
Use DNIS as Destination - the destination digits for each DID/DNIS number will
be the same as the DID/DNIS number. This option is normally used when the
DID/DNIS numbers match the telephone PDNs, PhDNs etc.
Start with - enter the number to which the first selected DID/DNIS number should
ring. Ringing destinations will be assigned consecutively, starting with this
number, to each consecutive DID/DNIS number.
Only Use - all selected DID/DNIS numbers will be assigned to the dialing digits
entered here.
Add to front - these digits will be added in front of each dialing digit number.
Add to end - these digits will be added to the end of each dialing digit number.
To Next Page