DRIVE SYSTEM
7-64 Rev. 000 TX525 Service Manual
8. Install the two hydraulic lines to the wheel motor
using a 1-1/8” 15°/60° offset open end wrench (Fig.
1504).
Note: To ease installation, connect the bottom
hydrauliclinerst.
Fig 1504 PICT-4461
9. For right hand wheel motor installation only: Slide
the battery partially into the battery mount. Install the
positive battery cable to the positive battery terminal.
Slide the battery further into the battery mount.
Install the negative battery cable to the negative
battery terminal. Slide the battery guard in between
the battery and the frame so that the hole in the
guard lines up with the battery clamp mounting hole
in the frame (Fig. 1505).
10. For right hand wheel motor installation only:
Position the battery clamp into the slot on the battery
mount and line up the mounting hole with the hole
in the frame. Install a bolt, washer and nut to secure
the battery clamp to the frame (Fig. 1506).
Fig 1505 PICT-4330
Fig 1506 PICT-4310a
To Next Page
Loading...
