Toro TX525 - Page 465

DRIVE SYSTEM
7-88 Rev. 000 TX525 Service Manual
5. Apply grease to the inside of the tensioner wheel
bore (Fig. 1590).
Fig 1590 PICT-4580
6. Place a washer into the greased wheel bore (Fig.
1591).
Fig 1591 PICT-4581
8. Slide the tensioner arm assembly out of the main-
frame (Fig. 1593).
Fig 1593 PICT-4584
7. Using a 1-1/2” socket, install a nut securing the ten-
sioner wheel to the tensioner arm shaft. Torque the
nut to 300 ft-lbs. (407 Nm) (Fig. 1592).
Fig 1592 PICT-4583