Toro TX525 - Page 69

ENGINE
4-16 Rev. 000 TX525 Service Manual
2. Positiontheradiator/oilcoolerassemblyintothe
framesoitisontopofthefoamsealsandbehind
the3radiatormountholes(Fig.0134).
5. Slidetheleftradiatorhoses(tophoses)ontothe2
radiatoranges(Fig.0136).
Fig 0134 PICT-5122
Fig 0136 PICT-5124
6. Slidethehoseclampsintopositionwiththetighten-
ingscrewheadsfacingoutwardasshown.Thiswill
allowaccesstothesetighteningscrewsthroughthe
grillassemblywhenitisinposition.Tightenthehose
clamps(Fig.0137).
3. Removetheprotectivecapsfromtheinletandoutlet
angesandttings.
4. Using1-1/16”and1-1/8”wrenches,installthehy-
draulicoilinletlinetotheoilcoolerinlettting(Fig.
0135).
Fig 0137 PICT-5125
Fig 0135 PICT-4965