TP-Link JetStream T3700G-28TQ - System Configuration Commands; system-time manual; system-time ntp

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
116
Example
Set the log host’s index as 2, IP address as 192.168.0.148 and the severity level
as 5:
T3700G-28TQ(config)#logging host index 2 192.168.0.148 5
copy logging flash tftp
Description
The copy logging flash tftp command is used save the log file in the flash to
the TFTP server.
Syntax
copy logging flash tftp ip-address ip-address filename file-name [ unit-id ]
Parameter
ip-address —— The address of the TFTP server to receive the log file.
file-name —— The name of the file to save the syslog.
unit-id —— Specify the unit ID of the switch in the stack. By default, the syslog
of all the units in the stack will be saved.
Command Mode
Global Configuration Mode
Example
Save the unit 1’s system log file to the TFTP server 192.168.0.148 with the
name log.txt:
T3700G-28TQ(config)# copy logging flash tftp ip-address 192.168.0.148
filename log.txt 1
clear logging
Description
The clear logging command is used to clear the syslog in the log buffer and log
flash in the specified unit or the whole stack.
Syntax
clear logging [ buffer | flash ] [ unit unit-id]