T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
304
T3700G-28TQ(config)# interface vlan 2
T3700G-28TQ(config-if)# ip igmp querier-timeout 100
ip igmp query-interval
Description
The ip igmp query-interval command is used to configure the interval of
General Query Messages that the switch sends on specified interface. To
restore to the default value on this interface, please use no ip igmp
query-interval command.
Syntax
ip igmp query-interval interval
no ip igmp query-interval
Parameter
interval —— Specify the interval of General Query Messages that the switch
sends. The default value is 60 seconds.
Command Mode
Interface Configuration Mode
Example
Configure the interval of General Query Messages that the switch sends as 50
seconds on interface VLAN 2:
T3700G-28TQ(config)# interface vlan 2
T3700G-28TQ(config-if)# ip igmp query-interval 50
ip igmp query-max-response-time
Description
The ip igmp query-max-response-time command is used to specify the max
response time to the General Query message on specified interface. To restore
to the default value on this interface, please use no igmp
query-max-response-time command.
Syntax
ip igmp query-max-response-time time
no ip igmp query-max-response-time
To Next Page
Loading...
