T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
273
T3700G-28TQ(config)#cluster individual
cluster management-vlan
Description
The cluster management-vlan command is used to specify the VLAN to
manage the clusters.
Syntax
cluster management-vlan vlan-id
Parameter
vlan-id —— Specify the cluster-management VLAN ID.
Command Mode
Global Configuration Mode
Example
Specify VLAN 2 as the VLAN to manage the clusters:
T3700G-28TQ(config)#cluster management-vlan 2
clear ndp statistics
Description
The clear ndp statistics command is used to clear statistics about NDP
messages on the specified port(s).
Syntax
clear ndp statistics [ interface { fastEthernet port | gigabitEthernet port |
ten-gigabitEthernet port } ]
Parameter
port —— Specify the Ethernet port number. The NDP statistics of all ports will
be cleared if the port number is not specified here.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Clear the statistics of the NDP messages on all the ports of the switch:
T3700G-28TQ(config)#clear ndp statistics
To Next Page
Loading...
