TP-Link JetStream T3700G-28TQ - Show Logging Local-Config; Show Logging Loghost

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
117
Parameter
buffer | flash —— The output channels: buffer and flash. Clear the information of
the two channels, by default.
unit-id —— The unit in which the syslog will be cleared. If not specified, all the
syslog in the stack will be cleared.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Clear the syslog in the log buffer of all the switches in the stack::
T3700G-28TQ(config)#clear logging buffer
show logging local-config
Description
The show logging local-config command is used to display the configuration
of the Local Log including the log buffer and the log file, the synchronization
frequency etc.
Syntax
show logging local-config
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the configuration of the Local Log:
T3700G-28TQ(config)#show logging local-config
show logging loghost
Description
The show logging loghost command is used to display the configuration of the
log host.
Syntax
show logging loghost [index]