T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
371
Command Mode
Router Configuration Mode
Example
Configure simple authentication as the authentication mode of a virtual-link with
the transmission area as Area 2 and the ID of the neighboring router on the
other endpoint as 3.3.3.3:
T3700G-28TQ(config)# router ospf 1
T3700G-28TQ(config-router)# area 2 virtual-link 3.3.3.3 authentication
area virtual-link authentication-key
Description
The area virtual-link authentication-key command is used to configure the
simple authentication key. To delete the key, please use the no area virtual-link
authentication-key command.
Syntax
area transit-area virtual-link router-id authentication-key key
no area transit-area virtual-link router-id authentication-key
Parameter
transit-area —— The transition area ID in the format of an IP address in dotted
decimal notation or decimal value ranging from 0 to 4294967295.
router-id —— The ID of the neighboring router on the other endpoint of the
virtual link, in the format of dotted decimal notation.
key —— The authentication string, ranging from 1 to 8 characters.
Command Mode
Router Configuration Mode
Example
Configure simple authentication as the authentication mode of a virtual-link with
the transmission area as Area 2 and the ID of the neighboring router on the
other endpoint as 3.3.3.3, and the authentication key as 123456:
T3700G-28TQ(config)# router ospf 1
To Next Page
Loading...
