T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
46
Parameter
tpid —— The value of Global TPID. It must be 4 Hex integers. By default, it is
8100.
Command Mode
Global Configuration Mode
Example
Configure Global TPID of the VLAN-VPN as 0x9100:
T3700G-28TQ(config)#dot1q-tunnel tpid 9100
dot1q-tunnel mapping
Description
The dot1q-tunnel mapping command is used to enable the VLAN Mapping
feature globally. To disable this function, please use the no dot1q-tunnel
mapping command. By default, the VLAN Mapping feature is disabled.
Syntax
dot1q-tunnel mapping
no dot1q-tunnel mapping
Command Mode
Global Configuration Mode
Example
Enable the VLAN mapping feature globally:
T3700G-28TQ(config)#dot1q-tunnel mapping
switchport dot1q-tunnel mapping
Description
The switchport dot1q-tunnel mapping command is used add the VLAN
Mapping entry on a specified port. To delete the VLAN Mapping entry on this
port, please use the no switchport dot1q-tunnel mapping command.
To Next Page
Loading...
