T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
26
Chapter 3 Stack
The stack technology is to connect multiple stackable devices through their StackWise ports,
forming a stack which works as a unified system and presents as a single entity to the network in
Layer 2 and Layer 3 protocols. This chapter describes how to manage the T3700G-28TQ switch
stacks.
switch priority
Description
The switch priority command is specify the stack member number and the new
priority for the stack member. To restore the priority of the specified stack
member to the default value as 5, please use no switch priority command.
Syntax
swtich unitid priority priority
no switch unitid priority
Parameter
unitid —— Specify the member number.
priority —— Specify the member’s priority, ranging from 1 to 15.
Command Mode
Global Configuration Mode
Example
Specify the unit 1’s priority as 10 in the stack:
T3700G-28TQ(config)# switch 1 priority 10
switch renumber
Description
The switch renumber command is modify the member number of a specified
stack member.
To Next Page
Loading...
