T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
353
Syntax
router-id router-id
no router-id
Parameter
router-id —— The route ID in the format of dotted decimal notation. 0.0.0.0 is
illegal.
Command mode
Router Configuration Mode
Example
Configure the router ID of OSPF routing process 1 as 1.1.1.1:
T3700G-28TQ(config)# router ospf 1
T3700G-28TQ(config-router)# router-id 1.1.1.1
network
Description
The network command is used to configure the network of a specified area. All
the interfaces fallen into the configured network will belong to this area. To
delete the specified network and its corresponding interfaces from this area,
please use the no network command.
Syntax
network ip-address wildcard-mask area area-id
no network ip-address wildcard-mask area area-id
Parameter
ip-address —— The IP address of the network.
wildcard-mask —— The wildcard mask of the network（such as 0.0.0.255）.
The subnet mask is also compatible （such as 255.0.0.0）.
area-id ——The area ID, in the format of an IP address in dotted decimal
notation or decimal value ranging from 0 to 4294967295.
Command Mode
Router Configuration Mode
Example
Configure the network 192.168.0.0/24 in the area 0.0.0.0:
To Next Page
Loading...
