T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
325
ip pim rp-address
Description
The ip pim rp-address command is used to configure the static RP. To disable
the static RP, please use no ip pim rp-address command.
Syntax
ip pim rp-address ip-addr [ override ]
no ip pim rp-address ip-addr
Parameter
ip-addr —— Specify the IP address of the static RP.
override —— The RP configured with this command prevails if there is a
conflict between the RP configured with this command and one learned by BSR.
Command Mode
Global Configuration Mode
Example
Configure the IP address of the static RP as 20.20.20.2:
T3700G-28TQ(config)# ip pim rp-address 20.20.20.2
ip pim bsr-border
Description
The ip pim bsr-border command is used to configure the border of the BSR
packet on each interface that connects to other bordering PIM domains. To
disable the border of BSR on this interface, please use no ip pim bsr-border
command.
Syntax
ip pim bsr-border
no ip pim bsr-border
Command Mode
Interface Configuration Mode
Example
Configure the BSR border on VLAN interface 2:
To Next Page
Loading...
