T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
216
T3700G-28TQ(config)#spanning-tree timer forward-time 16 hello-time 3
max-age 22
spanning-tree hold-count
Description
The spanning-tree hold-count command is used to configure the maximum
number of BPDU packets transmitted per Hello Time interval. To return to the
default configurations, please use no spanning-tree hold-count command.
Syntax
spanning-tree hold-count value
no spanning-tree hold-count
Parameter
value —— The maximum number of BPDU packets transmitted per Hello Time
interval, ranging from 1 to 20 in pps. By default, it is 5.
Command Mode
Global Configuration Mode
Example
Configure the hold-count of STP as 8pps:
T3700G-28TQ(config)#spanning-tree hold-count 8
spanning-tree max-hops
Description
The spanning-tree max-hops command is used to configure the maximum
number of hops that occur in a specific region before the BPDU is discarded. To
return to the default configurations, please use no spanning-tree max-hops
command.
Syntax
spanning-tree max-hops value
no spanning-tree max-hops
Parameter
value —— The maximum number of hops that occur in a specific region before
the BPDU is discarded, ranging from 1 to 40 in hop. By default, it is 20.
To Next Page
Loading...
