T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
201
redirect interface
Description
The redirect interface command is used to configure Direction function of
policy action for specified ports.
Syntax
redirect interface { fastEthernet port | gigabitEthernet port |
ten-gigabitEthernet port }
Parameter
port —— The Destination Port of Redirect. The data packets matching the
corresponding ACL will be forwarded to the specific port. By default, it is All
Ports.
Command Mode
Action Configuration Mode
Example
Edit the actions for policy1. Forward the data packets matching ACL 1200 in the
policy to Gigabit Ethernet port 1/0/2:
T3700G-28TQ(config)#access-list policy action policy1 1200
T3700G-28TQ(config-action)#redirect interface gigabitEthernet 1/0/2
s-condition
Description
The s-condition command is used to configure Stream Condition function of
policy action.
Syntax
s-condition rate rate osd {none | discard}
Parameter
rate —— The rate of Stream Condition, ranging from 0 to 10000000kbps.
osd —— Out of Band disposal of Stream Condition. It is the disposal way of the
data packets those are transmitted beyond the rate. There are two options,
“none” and “discard”. By default, the option is “none”.
Command Mode
Action Configuration Mode
To Next Page
Loading...
