TP-Link JetStream T3700G-28TQ - ip pim sg-expiry-timer; ip pim spt-threshold infinity

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
303
To restore to the default value on this interface, please use no ip igmp
last-member-query-interval command.
Syntax
ip igmp last-member-query-interval interval
no ip igmp last-member-query-interval
Parameter
interval —— Specify the interval of Specific Query Messages that the switch
sends. The default value is 1 second.
Command Mode
Interface Configuration Mode
Example
Configure the interval of Specific Query Messages that the switch sends as 2
seconds on Interface VLAN 2:
T3700G-28TQ(config)# interface vlan 2
T3700G-28TQ(config-if)# ip igmp last-member-query-interval 2
ip igmp querier-timeout
Description
The ip igmp querier-timeout command is used to configure the existing time of
the non-querier on specified interface. To restore to the default value on this
interface, please use no igmp querier-timeout command.
Syntax
ip igmp querier-timeout time
no ip igmp querier-timeout
Parameter
time —— Specify the existing time of the non-querier. The default value is 120
seconds.
Command Mode
Interface Configuration Mode
Example
Configure the existing time of non-querier as 100 seconds on Interface VLAN 2: