T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
137
UTC+08:00 —— TimeZone for Beijing, Chongqing, Hong Kong, Urumqi,
Singapore.
UTC+09:00 —— TimeZone for Seoul, Irkutsk, Osaka, Sapporo, Tokyo.
UTC+09:30 —— TimeZone for Darwin, Adelaide.
UTC+10:00 —— TimeZone for Canberra, Melbourne, Sydney, Brisbane.
UTC+11:00 —— TimeZone for Solomon Is., New Caledonia, Vladivostok.
UTC+12:00 —— TimeZone for Fiji, Magadan, Auckland, Wellington.
UTC+13:00 —— TimeZone for Nuku'alofa, Samoa.
ntp-server —— The IP address for the Primary NTP Server.
backup-ntp-server —— The IP address for the Secondary NTP Server.
fetching-rate —— Specify the rate fetching time from NTP server.
Command Mode
Global Configuration Mode
Example
Configure the system time mode as NTP, the time zone is UTC-12:00, the
primary NTP server is 133.100.9.2 and the secondary NTP server is
139.78.100.163, the fetching-rate is 11 hours:
T3700G-28TQ(config)# system-time ntp UTC-12:00 133.100.9.2
139.79.100.163 11
system-time dst predefined
Description
The system-time dst predefined command is used to select a predefined DST
configuration and the configuration can be recycled.
Syntax
system-time dst predefined [ USA | Australia | Europe | New-Zealand ]
Parameter
USA | Australia | Europe | New-Zealand —— Predefined DST mode, with four
options: USA, Australia, Europe and New-Zealand. By default, the setting is
“Europe”.
The DST time periods which the four predefined DST mode represents are
displayed as follow:
To Next Page
Loading...
