TP-Link JetStream T3700G-28TQ - holiday; holiday(global)

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
175
bandwidth
Description
The bandwidth command is used to configure the bandwidth limit for an
Ethernet port. To disable the bandwidth limit, please use no bandwidth
command.
Syntax
bandwidth { [ingress ingress-rate] [egress egress-rate] }
no bandwidth { all | ingress | egress }
Parameter
ingress-rate ——Specify the bandwidth for receiving packets. Range: 1-100000
kbps for the megaport, 1-1000000 kbps for the gigaport, 1 to 10000000 kbps for
the ten-gigabit port.
egress-rate —— Specify the bandwidth for sending packets. Range:1-102400
kbps for the megaport, 1-1000000 kbps for the gigaport, 1 to 10000000 kbps for
the ten-gigabit port.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Configure the ingress-rate as 5120kbps and egress-rate as 1024kbps for
Gigabit Ethernet port 5:
T3700G-28TQ(config)#interface gigabitEthernet 1/0/5
T3700G-28TQ(config-if)#bandwidth ingress 5120 egress 1024
clear counters
Description
The clear counters command is used to clear the statistic information of all the
Ethernet ports.