TP-Link JetStream T3700G-28TQ - auto-summary; default-metric

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
326
T3700G-28TQ(config)# interface vlan 2
T3700G-28TQ(config-if)# ip pim bsr-border
ip pim dr-priority
Description
The ip pim dr-priority command is used to configure the priority of DR. To
restore to the default value of DR priority, please use no ip pim dr-priority
command.
Syntax
ip pim dr-priority pri
no ip pim dr-priority
Parameter
pri —— Specify the priority of DR, ranging from 0 to 4294967294. The default
value is 1.
Command Mode
Interface Configuration Mode
Example
Configure the DR priority on interface VLAN 2 as 100:
T3700G-28TQ(config)# interface vlan 2
T3700G-28TQ(config-if)# ip pim dr-priority 100
ip pim join-prune-interval
Description
The ip pim join-prune-interval command is used to configure the interval of
join/prune packet. To restore to the default value, please use no ip pim
join-prune-interval command.
Syntax
ip pim join-prune-interval interval
no ip pim join-prune-interval