T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
50
Chapter 8 Voice VLAN Commands
Voice VLANs are configured specially for voice data stream. By configuring Voice VLANs and
adding the ports with voice devices attached to voice VLANs, you can perform QoS-related
configuration for voice data, ensuring the transmission priority of voice data stream and voice
quality.
voice vlan
Description
The voice vlan command is used to enable Voice VLAN function. To disable
Voice VLAN function, please use no voice vlan command.
Syntax
voice vlan vlan-id
no voice vlan
Parameter
vlan-id —— Specify IEEE 802.1Q VLAN ID, ranging from 2 to 4094.
Command Mode
Global Configuration Mode
Example
Enable the Voice VLAN function for VLAN 10:
T3700G-28TQ(config)#voice vlan 10
voice vlan aging
Description
The voice vlan aging command is used to set the aging time for a voice VLAN.
To restore to the default aging time for the Voice VLAN, please use no voice
vlan aging command. By default, the aging time is 1440 minutes.
Syntax
voice vlan aging time
To Next Page
Loading...
