TP-Link JetStream T3700G-28TQ - switchport dot1 q-tunnel mode

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
28
switch stack-name
Description
The switch stack-name command is customize the stack’s name. To restore to
the default name “Stack”, please use no switch stack-name command.
Syntax
swtich stack-name { name }
no switch stack-name
Parameter
name —— Specify the name of the stack.
Command Mode
Global Configuration Mode
Example
Specify the name of the stack as Stack1:
T3700G-28TQ(config)# switch stack-name Stack1
switch stack-port
Description
The switch stack-port command is used to enable the stack port. To switch the
stack port to Ethernet port, please use no switch stack-port command.
Syntax
swtich stack-port interface ten-gigabitEthernet port
no switch stack-port interface ten-gigabitEthernet port
Parameter
port —— The stack port number.
Command Mode
Global Configuration Mode