TP-Link JetStream T3700G-28TQ - SNMP Commands; snmp-server; snmp-server view

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
217
Command Mode
Global Configuration Mode
Example
Configure the max-hops of STP as 30:
T3700G-28TQ(config)#spanning-tree max-hops 30
spanning-tree bpdufilter
Description
The spanning-tree bpdufilter command is used to enable the BPDU filter
function for a port. With the function enabled, the port can be prevented from
receiving and sending any BPDU packets. To disable the BPDU filter function,
please use no spanning-tree bpdufilter command.
Syntax
spanning-tree bpdufilter
no spanning-tree bpdufilter
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable the BPDU filter function for Gigabit Ethernet port 1/0/2:
T3700G-28TQ(config)#interface gigabitEthernet 1/0/2
T3700G-28TQ(config-if)#spanning-tree bpdufilter
spanning-tree bpduguard
Description
The spanning-tree bpduguard command is used to enable the BPDU protect
function for a port. With the BPDU protect function enabled, the port will set itself
automatically as ERROR-PORT when it receives BPDU packets, and the port
will disable the forwarding function for a while. To disable the BPDU protect
function, please use no spanning-tree bpduguard command.
Syntax
spanning-tree bpduguard