T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
259
be sent out (the number of LLDPDUs equals this parameter). The value ranges
from 1 to 10 and the default value is 3.
Command Mode
Global Configuration Mode
Example
Specify the Transmit Interval of LLDPDU as 45 seconds and Trap message to
NMS as 120 seconds:
T3700G-28TQ(config)#lldp timer tx-interval 45
T3700G-28TQ(config)#lldp timer notify-interval 120
lldp receive
Description
The lldp receive command is used to enable the designated port to receive
LLDPDU. To disable the function, please use no lldp receive command.
Syntax
lldp receive
no lldp receive
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable Gigabit Ethernet port 1/0/1 to receive LLDPDU:
T3700G-28TQ(config)#interface gigabitEthernet 1/0/1
T3700G-28TQ(config-if)#lldp receive
lldp transmit
Description
The lldp transmit command is used to enable the designated port to transmit
LLDPDU. To disable the function, please use no lldp transmit command.
Syntax
lldp transmit
To Next Page
Loading...
