T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
271
Example
Configure the newly created cluster name as tp:
T3700G-28TQ(config)#cluster commander tp
cluster manage
Description
The cluster manage command is used to configure the hold time and interval to
send handshake packets of the cluster. To return to the default configuration,
please use no cluster manage command.
Syntax
cluster manage [ holdtime hold-time | timer interval-time ]
no cluster manage [ holdtime | timer ]
Parameter
hold-time —— Hold Time, which is the time for the switch to keep the cluster
information. Hold Time ranges from 1 to 255 in seconds. It is 20 by default.
interval-time —— Interval Time, which is the interval to send handshake
packets. Interval Time ranges from 1 to 255 in seconds. It is 20 by default.
Command Mode
Global Configuration Mode
Example
Specify the Hold Time and Interval Time of the cluster as 50 seconds:
T3700G-28TQ(config)#cluster manage holdtime 50
T3700G-28TQ(config)#cluster manage timer 50
cluster member
Description
The cluster member command is used to add member switch. To delete the
corresponding member, please use no cluster member command. The
add/delete operations of member switches should be implemented by the
commander switch according to the MAC address.
Syntax
cluster member {mac-address mac-address}
To Next Page
Loading...
