TP-Link JetStream T3700G-28TQ - Port isolation Commands; port isolation

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
171
duplex
Description
The duplex command is used to configure the Duplex Mode for an Ethernet
port. To return to the default configuration, please use no duplex command.
Syntax
duplex { auto | full | half }
no duplex
Parameter
full | half —— The duplex mode of the Ethernet port. There are three options:
auto-negotiation mode, full-duplex mode and half-duplex mode. By default the
Gigabit Ethernet port is auto-negotiation mode and the Ten Gigabit Ethernet port
is full-dulplex mode.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Configure the Duplex Mode as full-duplex for Gigabit Ethernet port 1/0/20:
T3700G-28TQ(config)#interface gigabitEthernet 1/0/20
T3700G-28TQ(config-if)#duplex full
speed
Description
The speed command is used to configure the Speed Mode for an Ethernet port.
To return to the default configuration, please use no speed command.
Syntax
speed { 10 | 100 | 1000 | 10000 | auto }
no speed