TP-Link JetStream T3700G-28TQ - show ip igmp groups port-info (dynamic); show ip igmp interface

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
299
Chapter 36 Proxy ARP Commands
The switch uses Proxy ARP to help hosts learn MAC addresses of hosts on other networks or
subnets.
ip proxy-arp
Description
The ip proxy-arp command is used to enable Proxy ARP function on the
specified VLAN interface or routed port. To disable IGMP function on this
interface, please use no ip proxy-arp command.
Syntax
ip ip proxy-arp
no ip proxy-arp
Command Mode
Interface Configuration Mode
Example
Enable the Proxy ARP function on Interface VLAN 2:
T3700G-28TQ(config)# interface vlan 2
T3700G-28TQ(config-if)# ip proxy-arp
Enable the Proxy ARP function on routed port 1/0/2:
T3700G-28TQ(config)# interface gigabitEthernet 2
T3700G-28TQ(config-if)# no switchport
T3700G-28TQ(config-if)# ip proxy-arp
show ip proxy-arp
Description
The show ip proxy-arp command is used to display the Proxy ARP status.
Syntax
show ip proxy-arp
Command Mode
Privileged EXEC Mode and Any Configuration Mode