T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
342
Chapter 41 RIP Commands
The Routing Information Protocol (RIP)is an interior gateway protocol (IGP) created for use in
small and homogeneous networks. It is a distance-vector routing protocol that uses broadcast
User Datagram Protocol (UDP) data packets to exchange routing information.
router rip
Description
The router rip command is used to enable the RIP function and enter router
configuration mode. To disable the RIP function, please use no router rip
command.
Syntax
router rip
no router rip
Command Mode
Global Configuration Mode
Example
Enable the RIP function and enter router configuration mode.
T3700G-28TQ(config)# router rip
T3700G-28TQ(config-router)#
network
Description
The network command is used to enable RIP function on interfaces of the
desired network. To disable the RIP protocol on these interfaces, please use no
network command.
Syntax
network network number
no network network number
To Next Page
Loading...
