TP-Link JetStream T3700G-28TQ - address client-identifier

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
270
Example
Enable NDP and NTDP function for Gigabit Ethernet port 1/0/5:
T3700G-28TQ(config)#interface gigabitEthernet 1/0/5
T3700G-28TQ(config-if)#cluster ndp enable ntdp enable
cluster ip pool
Description
The cluster ip pool command is used to create a new cluster. If no specified
cluster name is set through cluster commander command, the newly created
cluster will be named the system default name “tplink-cluster”.
Syntax
cluster ip pool ip mask
Parameter
ip —— The cluster IP address pool.
mask —— The cluster IP address mask.
Command Mode
Global Configuration Mode
Example
Create a cluster and configure its IP address pool as 192.168.10.1~
192.168.0.254:
T3700G-28TQ(config)#cluster ip pool 192.168.10.1 255.255.255.0
cluster commander
Description
The cluster commander command is used to specify the cluster name, and
you can only specify the cluster name before you create the cluster.
Syntax
cluster commander name
Parameter
name —— The cluster name, ranging from 1 to 16 characters.
Command Mode
Global Configuration Mode