TP-Link JetStream T3700G-28TQ - User Interface; enable; enable password; Protocol VLAN Commands

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
22
Chapter 2 User Interface
enable
Description
The enable command is used to access Privileged EXEC Mode from User
EXEC Mode.
Syntax
enable
Command Mode
User EXEC Mode
Example
If you have set the password to access Privileged EXEC Mode from User EXEC
Mode:
T3700G-28TQ>enable
Enter password：
T3700G-28TQ#
enable password
Description
The enable password command is used to set the password for users to
access Privileged EXEC Mode from User EXEC Mode. To return to the default
configuration, please use no enable password command.
Syntax
enable password password [ secret {simple | cipher} ]
no enable password
Parameter
password —— super password ， which contains 31 characters at most,
composing digits, English letters and underdashes only. By default, it is empty.
simple | cipher —— The way of displaying password in configuration file. By
default, it is “simple”.