T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
250
f-event —— Fall Event, which is the index of the corresponding event which will
be triggered if the sampled value is lower than the
Falling Threshold. It ranges
from 1 to 12.
a-type —— Alarm Type, with rise, fall and all options. Rise indicates that the
alarm event will be triggered when the sampled value exceeds the
Rising
Threshold
, fall indicates that the alarm event will be triggered when the sampled
value is under the
Falling Threshold, and all indicates that the alarm event will be
triggered either the sampled value exceeds the
Rising Threshold or is under the
Falling Threshold. By default, the Alarm Type is all.
owner-name —— The owner of the entry, ranging from 1 to 16 characters. By
default, it is monitor.
interval —— The alarm interval time, ranging from 10 to 3600 in seconds. By
default, it is 1800.
Command Mode
Global Configuration Mode
Example
Configure rmon alarm entries 1-3 binding with statistics entry 2, the owners as
owner1 and the alarm intervals as 100 seconds:
T3700G-28TQ(config)#rmon alarm 1-3 stats-index 2 owner owner1 interval
100
rmon statistics
Description
The rmon statistics command is used to configure the entries of SNMP-RMON
statistics. To delete the corresponding entry, please use no rmon statistics
command. The maximum supported entries are 1000.
Syntax
rmon statistics index interface { fastEthernet port | gigabitEthernet port |
ten-gigabitEthernet port } [ owner owner-name] [ status { underCreation |
valid }]
no rmon statistics index
Parameter
index —— The index number of the statistics entry, ranging from 1 to 65535, in
the format of 1-3,5.
To Next Page
Loading...
