TP-Link JetStream T3700G-28TQ - show ip ospf area retransmission-list

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
370
rtx-interval —— The retransmission interval of the LSA, DD and LSR packets. It
ranges from 1 to 65535 seconds and the default value is 5 seconds.
trans-delay —— The LSA transmission delay. It ranges from 1 to 65535
seconds and the default value is 1 seconds.
Command Mode
Router Configuration Mode
Example
Configure a virtual-link with the transmission area as Area 1 and the ID of the
neighboring router on the other endpoint as 1.1.1.1:
T3700G-28TQ(config)# router ospf 1
T3700G-28TQ(config-router)# area 1 virtual-link 1.1.1.1
area virtual-link authentication
Description
The area virtual-link authentication command is used to configure the
authentication type of the virtual link. The virtual link is not authenticated by
default. To restore to default value, please use the no area virtual-link
authentication command.
Syntax
area transit-area virtual-link router-id authentication [ message-digest | null ]
no area transit-area virtual-link router-id authentication
Parameter
transit-area —— The transition area ID in the format of an IP address in dotted
decimal notation or decimal value ranging from 0 to 4294967295.
router-id —— The ID of the neighboring router on the other endpoint of the
virtual link, in the format of dotted decimal notation.
message-digest —— Configure the configuration type as MD5.
null —— No authentication. By default it is no authentication.
If no authentication mode is specified here, the default mode will be simple
authentication.