T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
73
T3700G-28TQ(config)#user name tplink password password type admin
status enable
user access-control ip-based
Description
The user access-control ip-based command is used to limit the IP-range of
the users for login. Only the users within the IP-range you set here are allowed
to login. To cancel the user access limit, please use no user access-control
command.
Syntax
user access-control ip-based ip-addr ip-mask
no user access-control
Parameter
ip-addr —— The source IP address. Only the users within the IP-range you set
here are allowed to login.
ip-mask ——The subnet mask of the IP address.
Command Mode
Global Configuration Mode
Example
Configure that only the user with the IP address 192.168.0.148 is allowed to
login:
T3700G-28TQ(config)#user access-control ip-based 192.168.0.148
255.255.255.255
user access-control mac-based
Description
The user access-control mac-based command is used to limit the MAC
address of the users for login. Only the user with this MAC Address you set here
is allowed to login. To cancel the user access limit, please use no user
access-control command.
To Next Page
Loading...
