T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
20
Interface Configuration Mode: In this mode, users can configure one or several
ports, different ports corresponds to different commands
a). Interface gigabitEthernet/ten-gigabitEthernet: Configure parameters for an
Ethernet port, such as Duplex-mode, flow control status.
b). Interface range gigabitEthernet/ten-gigabitEthernet: Configure parameters for
several Ethernet ports.
c). Interface link-aggregation: Configure parameters for a link-aggregation, such as
broadcast storm.
d). Interface range link-aggregation: Configure parameters for multi-trunks.
e). Interface Loopback: Configure the parameters of the loopback interface.
f). Interface vlan: Configure parameters for the vlan interface.
Vlan Configuration Mode: In this mode, users can create a VLAN and add a
specified port to the VLAN.
Router Configuration Mode: In this mode, commands for configuring the Layer 3
functions are provided.
3. Some commands are global, that means they can be performed in all modes:
show: Displays all information of switch, for example: statistic information, port
information, VLAN information.
history: Displays the commands history.
1.3 Security Levels
This switch’s security is divided into two levels: User level and Admin level.
User level only allows users to do some simple operations in User EXEC Mode; Admin level
allows you to monitor, configure and manage the switch in Privileged EXEC Mode, Global
Configuration Mode, Interface Configuration Mode and VLAN Configuration Mode.
Users get the privilege to the User level once connecting console port with the switch or logging in
by Telnet. However, Guest users are restricted to access the CLI.
Users can enter Privileged EXEC mode from User EXEC mode by using the enable command. In
Global Configuration Mode, you can configure password for Admin level by enable password
command. Once password is configured, you are required to enter it to access Privileged EXEC
mode.
To Next Page
Loading...
