TP-Link JetStream T3700G-28TQ - MAC-based VLAN Commands; mac-vlan mac-address

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
19
Mode Accessing Path Prompt
Logout or Access the
next mode
Layer 2 Interface:
Use the interface
gigabitEthernet port or
interface range
gigabitEthernet port-list
command to enter this mode
from Global Configuration
mode.
T3700G-28TQ(config-if)#
T3700G-28TQ(config-if- range)#
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global Configuration
mode.
A port number must be
specified in the interface
command.
Interface
Configuration
Mode
Layer 3 Interface:
Use the no switchport
command to enter Routed Port
mode from Interface
Configuration mode.
Use the interface vlan vlan-id
command to enter VLAN
Interface mode from Global
Configuration mode.
Use the interface loopback id
command to enter Loopback
Interface mode from Global
Configuration mode.
T3700G-28TQ(config-if)#
T3700G-28TQ(config-if-
range)#
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global Configuration
mode.
DHCP
Configuration
Mode
Use the ip dhcp server pool
pool-name command to enter
DHCP Configuration Mode
from Global Configuration
mode.
T3700-28TQ(config-dhcp)
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global Configuration
mode.
MST
Configuration
Mode
Use the spanning-tree mst
configuration command to
enter this mode from Global
Configuration mode.
T3700G-28TQ(config- mst)#
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global configuration mode.
Note:
1. The user is automatically in User EXEC Mode after the connection between the PC and
the switch is established by a console port or by a telnet connection.
2. Each command mode has its own set of specific commands. To configure some
commands, you should access the corresponding command mode firstly.
 Global Configuration Mode: In this mode, global commands are provided, such as
the Spanning Tree, Schedule Mode and so on.