TP-Link JetStream T3700G-28TQ - show vlan

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
18
Mode Accessing Path Prompt
Logout or Access the
next mode
User EXEC
Mode
Primary mode once it is
connected with the switch.
T3700G-28TQ>
Use the exit command to
disconnect the switch
(except that the switch is
connected through the
Console port).
Use the enable command
to access Privileged EXEC
mode.
Privileged
EXEC Mode
Use the enable command to
enter this mode from User
EXEC mode.
T3700G-28TQ#
Enter the disable or exit
command to return to User
EXEC mode.
Enter configure command
to access Global
Configuration mode.
Global
Configuration
Mode
Use the configure command to
enter this mode from Privileged
EXEC mode.
T3700G-28TQ(config)#
Use the exit or the end
command or press Ctrl+Z
to return to Privileged
EXEC mode.
Use the interface
gigabitEthernet port or
interface range
gigabitEthernet port-list
command to access
interface Configuration
mode.
Use the vlan vlan-list to
access VLAN
Configuration mode.
Line
Configuration
Mode
Use the line vty command
from Global Configuration
mode to specify a line.
T3700G-28TQ(config- line)
Use the exit command to
exit to the global
configuration mode.
Press Ctrl-Z or enter end
to return to priviledged
EXEC mode.
VLAN
Configuration
Mode
Use the vlan vlan-list
command to enter this mode
from Global Configuration
mode.
T3700G-28TQ(config- vlan)#
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global configuration mode.
Router
Configuration
Mode
Use the router ospf process-id
to enter OSPF Router mode
from Global Configuration
mode.
Use the router rip command to
enter RIP Router mode from
Global Configuration mode.
T3700-28TQ(config- router)
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global Configuration
mode.