TP-Link JetStream T3700G-28TQ - GVRP Commands; gvrp; gvrp (interface)

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
43
port, please use no protocol-vlan command. By default, the Protocol-based
VLAN feature of all ports is disabled.
Syntax
protocol-vlan
no protocol-vlan
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable the Protocol-based VLAN feature for the Gigabit Ethernet port 25:
T3700G-28TQ(config)#interface gigabitEthernet 1/0/25
T3700G-28TQ(config-if)#protocol-vlan
show protocol-vlan template
Description
The show protocol-vlan template command is used to display the information
of the Protocol-based VLAN templates.
Syntax
show protocol-vlan template
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the information of the Protocol-based VLAN templates:
T3700G-28TQ(config)#show protocol-vlan template